Motorcycle Cruiser Homepage

Brakeserv-6-drain-lg

<i>Eventually you'll see only clean fluid flowing. At that point, tighten the bleed screw, pump the lever a few times and then, while holding the lever down, open the bleed screw as you normally would when bleeding the brakes. If no air bubbles or dirty fluid drains out, you're all done. If you're working on a dual-caliper brake, repeat the process on the opposite caliper. </i>
Motorcycle Brake Inspection & Service

 Eventually you'll see only clean fluid flowing. At that point, tighten the bleed screw, pump the lever a few times and then, while holding the lever down, open the bleed screw as you normally would when bleeding the brakes. If no air bubbles or dirty fluid drains out, you're all done. If you're working on a dual-caliper brake, repeat the process on the opposite caliper.   View Related Article

 

Car Research Guide